Standing Application Directions
Step 1: Trim
Clip your dog’s nails, if needed as well as the hair between your dog’s pads. An inexpensive trimmer works great.
Step 2: Clean
Clean your dog’s pads with water or rubbing alcohol. Make sure the pads are completely dry before proceeding.
Step 3: Prepare the Tray
Prepare the tray by lining it completely with the blue PawFriction traction granules. Replenish the granules as needed throughout the process to ensure even application.
Step 4: Prepare the Adhesive
Simply cut the tip of the adhesive tube 1/3 way down the tip at a 45-degree angle.
Step 5: Applying the Adhesive
With the tray underneath the paw, gently bend your dog’s leg at the knee and apply a thin layer of the PawFriction adhesive to the paw pads. Focus on the areas that contact the ground, and avoid getting any in your dog’s hair.
Step 6: Applying the Granules
Immediately straighten your dog’s leg back into standing position and press the entire paw into the PawFriction tray. Lift the paw and press it down again. Hold for 30 seconds.
Step 7: Clean and Repeat
Gently brush excess PawFriction granules off your dog’s paw and repeat the process for each leg.
Step 8: Treat Time
Reward your dog’s good behavior with a treat, and store leftover granules and adhesive for your next application.